WVO Centrifuges
Home Your Account Your Shopping Cart


Bookmark and Share

Raw Beast Centrifuge

The Raw Beast Centrifuge eliminates the need for filtering, settling, pumping, pressure and headaches.

This centrifuge has the ability to produce fuel quality oil from a variety of waste oils including waste motor oil, wmo, waste vegetable oil, ATF, hydraulic oil and basically any kinds of waste oils.

This centrifuge spins at 4000rpms and produces over 2800 units of G-force. The dirt and water get trapped in the centrifuge bowl, while the clean oil sprays out over the top, collecting on the sides of the housing, then flowing out the drain tube.

The centrifuge bowl will hold 210ozs of contaminants and will clean to <1 micron at 40 gallons per hour.

This centrifuge works by applying g-force to a liquid, causing a settling of the denser particles and fluids to occur. Water and dirt are heavier than oil, so the centrifugal forces pull the unwanted particles and liquids out of the oil. This allows you to safely burn the oil in a diesel vehicle or convert into biodiesel.

A custom 4000rpm motor from Baldor and made in USA. Motor is 1.5 HP and variable speed. 20 Year Lifespan with sealed bearings. A 3 phase 230v continuous heavy duty motor with a 3 phase to single phase converter.

The unique lid design aids in the removal of water. Water is a primary target when cleaning oil. This unique design allows you to vent off water that turns to steam when heated or that happens to make it out of our bowl in the mist spray.

This centrifuge is gravity fed and designed to be a single pass system. No messy filters to buy, change or monitor.

It is recommended to heat the oil to at least 150F for better separation which will allow a flow rate of 50-150gph. Ideal temperature range is 150-200 degrees F. Non-heated oil can be used, but not nearly as effective. This will lower the flow rate depending on the temperature and the quality of the oil.

Pneumatically controlled arm that will purge out liquid waste from the bowl. Customize interval with a timer that will allow it to clean continuously.

230 volt

Comes pre-assembled and pneaumatic controls are included.

1 Year Limited Warranty: This centrifuge comes with a free replacement of any part that wears out or breaks during the first year. This warranty includes seals, latches, bearings, cast structure, and the rotor. Labor for repair and shipping is not included.

5 Year Replacement Warranty On Major Components: Our centrifuge comes with a 5 year replacement warranty on non wear items such as bearings, seals and brushes. Shipping is not included.

Please allow 2 to 3 weeks for delivery.